Tube chair – 10mm aluminum polished tube chair. Aluminum tubes are bent by careful heat induction. An induction coil is placed around a small section of the pipe at the bend point. It is then heated to sufficient temperature. While the pipe is hot, pressure is placed on the pipe to bend it. The pipe is then quenched with either air or water spray.

Share on Facebook
Share on Twitter
Share on LinkedIn
Save on Delicious
Digg This
+1
Pin it on Pinterest
Submit to reddit
Submit to StumbleUpon
Share on Tumblr
Categories: PortfolioCat1
Share on Facebook
Share on Twitter
Share on LinkedIn
Save on Delicious
Digg This
+1
Pin it on Pinterest
Submit to reddit
Submit to StumbleUpon
Share on Tumblr